GYS SMARTFEED M-4 Manual Del Usuario página 11

INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorised by the manufacturer should perform the installation of the welding equipment. During the installation, the
operator must ensure that the machine is disconnected from the mains. It is recommended to use the welding cables supplied with the unit in order
to obtain the optimum product settings.
DESCRIPTION OF THE EQUIPMENT (I)
1- Euro connector
2- Power relay connector
3- Air output connector
4- Crash sensor connector
5- Optional input/output connections
6- Welding power source connector
7- Connector for wire end sensor
8- Air inlet connector
POWER SUPPLY - POWER UP
The SMARTFEED M-4 robotic wire feeder has been designed to work exclusively with the NEOPULSE range:
- NEOPULSE 500 G (ref. 014503)
- NEOPULSE 400 G (ref. 014497)
- NEOPULSE 320 C (ref. 062474)
This reel can be used with manual and robotic MIG-MAG torches. The connection between these two elements is made through a dedicated beam.
PRECAUTIONS
Make sure the welding generator is switched off when connecting or disconnecting the wire feeder.
WIRE LOADING
a
b
- Check the marking on the roller to ensure that the rollers are suitable for the diameter of the wire
and the material of the wire (for a Ø 1.2 wire, use the Ø 1.2 groove).
- Use rollers with V-groove for steel and other hard wires.
- Use rollers with U-slots for aluminium and other soft alloy wires.
: visible inscription on the roller (example: 1.2 VT)
: groove to be used
OPTIONAL CONNECTORS
The SMARTFEED M-4 is equipped with a flap on the front panel (I-5) that allows access to a 10-pin connector. This connector allows the user to
have additional inputs/outputs for automation options.
SMARTFEED M-4
+ HMI remote option possible
a
To change the rollers, proceed as follows:
- Loosen the rollers (a) to the maximum and lower them.
- Unlock the rollers by turning the retaining rings (b) a quarter turn.
- Fit the appropriate drive rollers for your application and lock the retaining bands.
The rollers supplied are double steel groove rollers (1.0 and 1.2).
To install the welding wire, proceed as follows:
- Loosen the knobs as much as possible and lower them.
- Insert the wire, then close the motorised reel and tighten the knobs according to the instructions.
- Operate the motor by pressing the manual wire feed button (I-9).
9- Gas inlet connector
10- Manual motor control (wire feed)
11- Manual motor control (wire recoil)
12- Manual operation of the gas solenoid valve (venting)
13- Manual operation of the air solenoid valve (cleaning)
14- Hatch for insertion of a wire connector
15- LED supply voltage presence
16- Wire feeder motor
(ref. 062122)
EN
11