Brizo RP48040 Serie Manual Del Usuario

NOTE: It is suggested that you anchor your shower arm and tub spout elbows or water lines.
3
SHOWERHEAD AND SHOWER ARM INSTALLATION:
Install a 1/2" threaded pipe nipple to extend beyond the finished wall 3/8" to 1/2".
Apply Teflon ® tape to thread on pipe nipple and screw brass adapter (1) securely
onto nipple. Apply Teflon tape to outlet end of shower arm (3) and screw
®
showerhead (2) onto the shower arm, using provided wrench (4) to tighten
A.
(3) = 3/8" - 1/2" (9.5 mm - 12.7 mm)
TUB SPOUT INSTALLATION:
Install 1/2" (13 mm) threaded pipe nipple (1) to extend past finished wall (2) per
A.
dimension (3).
Connection of deck mount spouts to in–wall valves is not recommended. Neither
is the use of hand showers connected to tub spouts in a tub/shower push button
diverter combination, or hand showers connected in lieu of a tub spout to a tub /
shower valve.
Piping between valve body and tub spout must be a minimum of 1/2" (13 mm)
copper pipe or 1/2" (13 mm) iron pipe in a straight drop no less than 8" (203
mm) but no more than 18" (457 mm) long with only one iron pipe or copper 90
degree elbow to the tub spout nipple.
63911 Rev. A
1
4
2
1
3
2
RP48040s Shower Arm
RP62603s Shower Arm
RP62605s Tub Spout
3
securely. Check position of set screw on top of shower arm (3) making sure it is
not sticking through to the inside opening where it could interfere with the
assembly. Slide shower arm and head assembly over the adapter and tighten set
screw against the adapter.
B.
3
Install a 1/2" threaded pipe nipple to extend beyond the finished wall 3/8" to
B.
1/2". Apply Teflon ® tape to thread on pipe nipple and screw brass adapter (1)
securely onto nipple. Check position of set screw on bottom of spout (2)
making sure it is not sticking through to the inside opening where it could
interfere with the assembly. Slide tub spout over the adapter and tighten set
screw, on bottom of spout, against the adapter. Note: This spout utilizes a
pull down diverter mechanism. To divert from spout to shower, pull
down on spout tip (3).
1
1
4
2
1
2
4/7/10