Turning Off The Heater; Safety Devices; Moving And Transporting The Heater; Preventative Maintenance Programme - Gude IND. 25 E Manual De Instrucciones

HOT AIR GENERATOR
8
GB
suffi cient and may activate the fl ame cut out mechanism, which
will turn off the heater;if this happens, wait for about a minute
and then press the reset button 1 (Fig. 2) to start the machine
again.
The fi rst steps to take if the machine does not work are the
following:
1. Check that there is fuel in the tank.
2. Press the reset button 2 (Fig.2) ON.
3. If the heater still
"TROUBLESHOOTING"guide.

TURNING OFF THE HEATER

To turn off the machine, move switch 1 (Fig. 2) to the "0" position
The fl ame will go off and the fan will continue to function until the
combustion chamber has cooled down completely.

SAFETY DEVICES

The heater is equipped with an electronic device to control the
fl ame.If there is an anomaly in the functioning, the machine will
be turned off and the reset button light 2 (Fig.2) will come on.
An over-heating thermostat cuts in and shuts off the fuel supply
if the heater overheats:the thermostat resets itself automatically
when the temperature in the combustion chamber diminishes
and reaches the maximum permitted value.
Before turning the heater on again, the cause of the overheating
must be identifi ed and removed (for example, a blockage in the
suction orifi ce and/or of the air fl ow duct, the non-functioning
of the fan). To turn on the machine again, press the reset but-
ton and repeat the specifi c instructions outlined in the section
"STARTING THE HEATER".
MOVING AND TRANSPORTING
THE HEATER
WARNING The following steps must be carried out befo-
re moving the heater: turn the heater off, following the
instructions in the previous section; disconnect the plug
from the power supply and wait for the heater to cool.
Before lifting or moving the heater, make sure that the fuel tank
cap is fi rmly in place.
To move the heater, simply grasp the support handle and wheel
the heater.
PREVENTATIVE
CE PROGRAMME
To ensure that the heater continues to work properly, it is neces-
sary to periodically clean the combustion chamber, the burner
and the fan.
WARNING The following steps must be carried out befo-
re servicing the heater: turn the heater off, following the
instructions in the previous section; disconnect the plug
from the power supply and wait for the heater to cool.
Every 50 hours of use it is necessary to:
• Dismantle the fi lter cartridge, remove it and clean it with clean
fuel oil.
• Remove the exterior cylindrical casing and clean the inside
and the blades of the fan.
does not work, consult
MAINTENAN-
• Check the condition of the cables and the high voltage connec-
tions on the electrodes.
• Dismantle the burner, clean the parts, then clean the electro-
des and regulate them to the distance indicated on page 95 in
the electrode regulation diagram.
the