Quick DCS 1083 Manual De Instalacion Y Uso página 10

INSTALLATION AND OPERATION
GB
EQUIPMENT SUPPLY
Connect the positive terminal of the charge source (alternator or battery charger) to the input terminal of the charge
separator (+ IN).
Connect the positive terminal of the battery or battery group to one of the output terminals of the charge separator. If
there are two batteries or battery groups, we recommend always using the output terminals + A OUT and + B OUT.
Connect the negative of the charge source and of the battery to the same negative bar.
The S terminal can be used to compensate voltage drop in the charge separator for sources where present.
Refer to the manual of the source in use in order to complete the connection to the compensation input.
Make the connections as in figure:
BATTERY CHARGER
BATTERY
CHARGER
*
FUSE
XXX
DCS 1083/1123
BATTERY
12/24V
BATTERY
CHARGERS
*
FUSE
DCS 2083/2123
BATTERY
12/24V
The instrument starts to divide the charge as soon as the charge source (switched on) is connected to the input terminal.
10
BATTERY BATTERY
12/24V 12/24V
*
FUSE
XXX
BATTERY BATTERY
12/24V 12/24V
* Compensation input (where present).
ALTERNATOR
ALTERNATOR
B + B -
*
FUSE
XXX
DCS 1083/1123
BATTERY
12/24V
ALTERNATORS
B + B -
*
FUSE
XXX
DCS 2083/2123
BATTERY
12/24V
BATTERY BATTERY
12/24V 12/24V
B - B +
*
FUSE
BATTERY BATTERY
12/24V 12/24V
DCS - REV001A