MWE7006
WARNING!
!
Secure the parts of the parking aid installed in the vehicle in
such a way that they cannot become loose under any circum-
stances (sudden braking, accidents) and cause injuries to the
occupants of the vehicle.
Do not fit the parts of the parking aid installed where an airbag
may open. This could cause injury if the airbag opens.
The parking aid is intended as an additional aid, which means it
does not relieve you of the obligation to take due care when
manoeuvring.
NOTICE!
A
Installing the parking aid can cause problems on vehicles with
LED tail lights.
If you would like to install the sensors on metal bumpers, you
require suitable adapters (not included in the scope of delivery).
Do not expose the control electronics to dampness.
The control electronics must not be installed near other control
modules.
The sensors may not cover signal lamps.
When fitting the sensors, make sure there are no objects fixed
to the vehicle (such as a bicycle rack) that are in the detection
range of the sensors.
EN
Safety and installation instructions
5