Setting The System - Dometic MWE 7006 Manual De Instrucciones

MWE7006
10

Setting the system

See fig. c to fig. f
!
WARNING!
Incorrect settings can impair operational safety.
The control electronics have the following control elements:
No. in fig. d
1
2, 3
I
NOTE
 To save the settings, disengage and engage the reverse gear
and wait for 2 s.
 To cancel setting the parameters without saving your
changes, or to stop the entire setting process: refrain from
pressing any buttons for a while.
Restoring the factory settings
➤ Press the right-hand button for longer than 2 s to access programming
mode.
➤ The display now shows 01.
➤ Press both buttons for longer than two seconds.
✓ The display shows F5.
EN
Designation
Display
F5
C5
Buttons for setting the system
Factory settings activated
Your own settings
Setting the system
11