Carry Handle - Black and Decker BDSL301 Manual De Instrucciones

ENGLISH
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The spotlight must be placed in a well ventilated area when
charging.
All batteries lose charge with time, specially when they are
warm. Recharge the unit every two months for 24 hours
when not in frequent use.
If the unit is not going to be used for extended periods,
disconnect the charger and store in a cool, dry place.
The following symbols are found on your charger:
Your charger is double insulated; therefore no earth
wire is required.
Read all of this instruction manual carefully.
This appliance is intended for indoor use only
130 o C
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
This product must not be disposed of with normal
household waste.
4
Features
This appliance includes some or all of the following features:

1. Carry handle

2. 2 Position brightness switch (high and low setting)
3. Charging LED indicator
4. Carry lanyard
5. Trigger lock
6. Pistol grip
7. On/off trigger switch
8. Charging socket
9. Quartz halogen bulb
10. Charger jack plug
11. Mains charger adaptor
Charging the spotlight (fig. A & B)
This spotlight is shipped in a partially charged state.
Charge the spotlight before first use using the mains
charging adaptor (11) for 24 hours or until the green
charging LED (3) lights.
Charge after each use until the green charging LED
indicator (3) lights.
The LED (3) indicates the battery level whilst charging.
One red LED indicates that the unit requires charging.
Two red LEDs indicate a high level of charge remaining.
The green LED lights shows the unit is fully charged.
Charging with the mains charger (fig. B)
Make sure that the spotlight is off (the trigger lock (5) is
in the off position and the trigger (7) is not pressed).
Note: To ensure optimum battery life do not charge for
longer than 48 hours.
Insert the charger jack plug (10) into the charging socket
(8).
Insert the mains charging adaptor (11) into a mains
power socket.
Charge until the green charging status LED (3) lights
(approximately 24 hours).
Use
Before operating the spotlight remove the charger jack
plug (10) from the charging socket (8).
Operating the spotlight (fig. C)
Move the trigger lock (5) to the unlocked position.
To lock the trigger switch (7) in the on position, press the
trigger switch (7) and push in the trigger lock (5).
To shut the spotlight off, press the trigger (7) and move
the trigger lock (5) to the unlocked position.
Release the trigger (7).