DeWalt DW631K Traducido De Las Instrucciones Originales página 24

E N G L I S H
Connecting a dust extractor (fig. A)
• Whenever possible, connect a dust extraction
device designed in accordance with the relevant
regulations regarding dust emission.
• Connect a dust extractor hose to the dust
extraction spout (11).
• Connect the other end of the hose to a suitable
dust extractor.
Instructions for use
Always observe the safety instructions
and applicable regulations.
Prior to operation:
• Check that the cutter is correctly installed in
the collet.
• Set the cutting depth.
• Connect a dust extractor.
• Always make sure the motor is locked to
the base before switching on.
Switching on and off (fig. A)
• To switch the tool on, set the switch to
the I position.
• To switch the tool off, set the switch to
the O position.
Trimming with ball bearing or pilot cutters
• Remove the copy follower.
• Switch the tool on.
• Move the tool at constant speed, keeping the ball
bearing or pilot cutter firmly against the workpiece.
• Switch the tool off.
Trimming shaped edges
• Install the copy follower when using cutters
without ball bearing or pilot.
• Adjust the copy follower as described above.
• Switch the tool on.
• Move the tool at constant speed, keeping the ball
bearing or pilot cutter firmly against the
workpiece.
• Switch the tool off.
en - 5
Trimming straight edges
• Install the straight guide on the copy follower as
described above.
• Proceed as for shaped edges.
It is also possible to trim straight edges using the
copy follower only.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
WALT repair
E
17