Kohler Lavinia K-2367 Instrucciones De Montaje página 3

Drain Body
Foam Gasket
(supplied with lavatory)
Roll the O-ring onto the
drain body and seat into the
underside of the lavatory.
Washer
1. Install the Lavatory
CAUTION: Risk of product damage. Do not overtighten
connections.
Position the lavatory on the countertop at the installation location.
Trace the lavatory drain hole onto the countertop.
Remove the lavatory and set aside.
Drill a 1-5/8" (4.1 cm) hole, at the marked location.
Discard the gasket supplied with the drain.
Slide the foam gasket onto the drain body.
Insert the drain body into the lavatory drain hole.
Roll the O-ring onto the drain body. Roll the O-ring up the drain
body until it is seated in the underside of the lavatory.
Align the lavatory and drain body assembly with the drain hole
in the countertop. Lower the drain body through the countertop
drain hole until the lavatory rests on the countertop.
Slide the washer onto the drain body.
Thread the nut onto the drain body.
Kohler Co.
O-Ring
(supplied with lavatory)
1-5/8" (4.1 cm)
Drain Hole
Nut Discard gasket
supplied with the drain.
3 1066948-2-C