Safety Instructions; General Safety - Dometic MCS5 Instrucciones De Montaje

_IA_MCS.book Seite 10 Mittwoch, 28. Januar 2009 9:06 09

Safety Instructions

Action: This symbol indicates that action is required on your part. The
required action is described step-by-step.
This symbol describes the result of an action.
fig. 1 5, page 3: This refers to an element in an illustration. In this case,
item 5 in figure 1 on page 3.
Please observe the following safety instructions.
2 Safety Instructions
The manufacturer will not be held liable for claims for damage resulting
from the following:
Faulty assembly or connection
Damage to the appliance resulting from mechanical influences and
excess voltage
Alterations to the device without express permission from the manu-
facturer
Use for purposes other than those described in the operating manual
2.1

General Safety

d This system does not meet requirements for ignition protection. Do not
install in spaces containing gasoline engines, tanks, LPG/CPG cylin-
ders, regulators, valves or fuel line fittings.
Failure to comply may result in injury or death.
Do not terminate condensate drain line
– within 1 m of any outlet of engine or generator exhaust systems,
– in a compartment housing of an engine or generator,
– in a bilge, unless the drain is connected properly to a sealed con-
Failure to comply may allow bilge or engine room vapors to mix with
the air conditioners return-air and contaminate living areas which
may result in injury or death.
In order to prevent the ingress of carbon monoxide (CO) or other
harmful vapors, a trap should be installed in the condensate drain
line(s).
Installation and servicing of this system can be hazardous due to
system pressure and electrical components.
Wear safety glasses and work gloves.
Place a fire extinguisher close to the work area.
10
densate or shower sump pump.
MCS5, MCS15