Lifetime 60351 Instrucciones De Montaje página 31

Tabla de contenido

Publicidad

SECTION 4 (CONTINUED) /
TOOLS AND PARTS REQUIRED /
4.9
• There is a narrow groove (illustrated in black) running along the outside of the window on the back of each Door.
Starting at the top, left corner of the groove in the Left Door, lay the Butyl Tape (EPH) into the groove. Do not worry about
getting the tape completely into the groove just yet—simply lay the tape over the groove. Do not press the tape into the groove. Do
not stretch the tape. Work your way downward (1) and, as you get to each corner, peel off the paper backing from the
tape you just laid (peel off backing at each corner). Go along the bottom (2) of the window. Curve your way upward
(3) and then along the top (4) of the window until you're back where you started. Clip off the excess.
• Une rainure étroite (illustrée en noir) se trouve le long de l'extérieur de la fenêtre à l'arrière de chaque porte.
Partant du coin supérieur gauche de la rainure de la porte gauche, étendre de ruban de butyl (EPH) dans la rainure.
Ne pas s'inquiéter si le ruban n'est pas complètement dans la rainure en ce moment, ne faire que déposer le ruban sur la rainure.
Ne pas étirer le ruban. Ne pas pousser le ruban dans la rainure. Travailler vers le bas (1) et, en approchant chaque
courbe, retirer le papier protecteur du ruban qui à été étendé (retirer le papier protecteur a chaque courbe).
Étendre le ruban le long du bas (2) de la fenêtre. Courber vers le haut (3), puis le long du haut (4) de la fenêtre
jusqu'à ce qu'il soit au point de départ. Couper l'excédent.
• Hay una ranura angosta (ilustrada en negro) bordeando la ventana en la superfi cie posterior de cada puerta.
Comenzando desde arriba, en la esquina izquierda de la ranura en la puerta izquierda, aplicar de de cinta butílica
(EPH) en la ranura. Ne preocuparse por poner la cinta completamente en la ranura, mas solamente sobre la ranura. No presionar
la cinta dentro de la ranura. No estirar la línea. Seguir hacia abajo (1) y, al acercar cada ángulo, quitar el papel protector
de la cinta que apenas aplicó (quitar el papel protector a cada ángulo). Seguir a lo largo del borde inferior (2) de la
ventana. Curvearla hacia arriba (3) y, entonces, a lo largo del borde superior (4) de la ventana hasta estar al punto
de partida. Cortar el exceso.
Groove /
Rainure
/
Ranura
SECTION 4 (SUITE)
/
OUTILS ET QUINCAILLERIE REQUIS
1
SECCIÓN 4 (CONTINUACIÓN)
/
INSTRUMENTAL Y HERRAJE REQUERIDOS
EPH (x1)
4
31
3
2

Publicidad

Tabla de contenido
loading

Tabla de contenido