PoolMaster 54507 Manual Del Usuario página 2

Step 4
Attach above assembly (A) and (B) to
previous assembly (C) and (D) and loosely
tighten. Before securely tightening the collar
nuts for the Spray Head (A) and Riser (B),
make sure that both the Spray Head and Riser
Arm are oriented in the directions and
positions you desire for the waterfall to spray.
Once in their correct positions, tighten all the
collar nuts to secure.
Step 5
Adjusting your waterfall height is a trial and
error process. Turn your pool pump o to
start this process. Once your pump is o ,
rotate the Inlet Connector sleeve to a large or
small opening, depending upon your desired
height. . A smaller opening will yield a higher
waterfall. Once the sleeve is rotated to the
estimated opening, securely tighten the
collar nut on the Inlet Connector and turn
your pool pump on to test the waterfall
height.
If you need to adjust the height, turn your
pump o , loosen the collar nut on the Inlet
Connector sleeve and adjust opening.
Tighten the collar nut and turn pump back
on. Repeat this process as needed until
desired waterfall height is achieved.
Step 6
Once waterfall height is achieved, go back
and securely tighten the collar nuts in all
locations. Gentle use of a wrench, such as a
pipe wrench or channel lock plier may be
needed.
(A)
(C)
(A) (A)
(B)
(A)
(B)
(D)
(B)
Large Opening
Small Opening
(B)
Pool Edge
Pool Wall
Return
2