König Electronic KN-VIDMEMO10 Manual De Uso página 3

Grabador de recordatorios de vídeo
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
8 to 12 hours fully charge a battery. For an accurate charging time, and further instructions on battery
keep and maintenance, please refer to the safety instructions of the battery and the charger or contact
your dealer.
2. Press and hold the Power button for one second to turn the power on or off.
NOTE: This device will turn off automatically if it is idle for 10 seconds.
3. Press the REC button to start recording, and press the REC button again to stop recording (the device
will stop recording automatically after 60 seconds).
- There are 3 memory positions that allow you to record 3 video messages; each message can be max.
60 seconds long
- In recording mode, press the POWER button to stop recording without saving the message
- When a video message is recorded, the LED will be blinking until the message is watched
- The latest recorded message will always be saved at memory #1, and move the last recorded
message to next memory position (# 2, and then #3).
4. Press one of the PLAY buttons to play or pause the recorded video message.
- Make sure that all the messages have been played before you remove the batteries, because all the
video messages will be erased
- Do not take the batteries out when the device is powered on; otherwise the recorded video messages
will be erased
5. Please insert new batteries when the "Battery Low" message is displayed on the LCD screen.
Maintenance
Always keep your video memo in proper condition.
Video Memo
• Use dry, soft, and clean cloth to wipe off fingerprints and dust on the lens and LCD screen
• Do not expose the device to direct sunlight or high temperatures
• When transferring the memo recorder from an area with low temperature to a area with high
temperatures (or the other way around), please wait a few minutes before using the memo recorder
Batteries
• Do not mix alkaline and rechargeable batteries.
• It is normal that batteries generate heat during use. However, if you feel it may be over-heated you can
turn the device off for a while
• Remove "dead" batteries as soon as possible since they are more likely to leak. If the unit will not be
used for several months, remove the batteries, as they could leak during that time
• When installing batteries, all batteries should be replaced at the same time. Do not mix fresh and used
batteries. Do not dispose of batteries in a fire, as they may explode
• Do not attempt to open batteries, as this may lead to overheating, distortion of the equipment, fire,
electrical shock or other hazards
Safety
• To avoid the danger of electric shock, do not open the device or try to fix the device yourself
• Keep the device in dry conditions, humidity may cause failure of the video memo
• Stop using the device immediately if the video memo is affected with damp. It is necessary to dry the
device in the air before using it again
Specifications
• Display: 1.5" TFT-LCD screen
• Power source: powered by 2x AAA Alkaline battery (not incl.)
• Battery lifetime: approx 2 ~ 3 weeks (or approximately 100 minutes of use)
• Memory capacity: internal memory to store up to three 60-seconds long video memos
• Camera: built-in
• Microphone: built-in
• Speaker: built-in
• Magnet: built-in
3

Publicidad

Tabla de contenido
loading

Tabla de contenido