Jacuzzi Bianco AT1201-DF Manual De Instrucciones página 10

7. Water Supply Line
Connect the water supply line (not included)
between the tank (A) and shut-off
valve. Tighten the tank connection coupling
nut 1/4 turn beyond hand tight. (DO NOT
OVERTIGHTEN.)
Turn on supply valve and allow tank (A) to fill.
Check for leaks at all connections and tighten
or correct as needed.
8. Tank Water Level Adjustment
The fill valve and tank water level are set at
the factory and should not require adjustment.
However, the water level is controlled by the
float on the fill valve and can be adjusted by
turning the adjustment inner pipe as necessary.
9. Install Tank Lid and Seat
Place seat (C) on bowl (B), centering
the hinges over the holes in the bowl (B).
Place plastic seat washers (LL) on plastic seat
bolts (NN) and insert plastic seat bolts (NN)
into hinge holes. Using a screwdriver (not
included) and plastic seat nuts (MM), secure
seat (C) to toilet bowl (B). Close hinge covers.
Hardware Used
Plastic
LL
Seat Washer
Plastic
MM
Seat Nut
Plastic
NN
Seat Bolt
7
8
Adjustment
Inner Pipe
9
C
x 2
x 2
x 2
10
LL
NN
A
B