Screen Assembly - Solter fox Manual De Instrucciones

FILTERS SELECTION TABLE ACCORDING TO APPLICATION
CURRENT PLASMA
IN AMPS CUT
0,25
0,5
0,75
1
2,5
5
10
15
20
30
40
60
80
TONE 11
100
125
150
175
200
TONE 12
225
250
275
300
TONE 13
350
400
450
500

SCREEN ASSEMBLY

A: Remove the protective film from both sides and fit in the lower tabs(1). Once fitted, press until it fits
with the upper tabs (2).
B: To clear the protectors of the later Protector and to place it in the space of the screen destined to
the filter.
C: To put the crystal in the right groove over the later protector and soon to press-the by the left part
towards the screen until tongue-piece holds it to the plastic.
D: To take the screen outer and to connect-to the screen as it is indicated in the figure. It faces two la-
teral presses the parts superiors until hearing "click". Be sure of which well the parts are fitted.
E: To place the positioner in the position adapted to our needs, on this position partly depends the
angle of the screen when the user has putting.
F: To place harness i to connect-to the screen by means of the screw and the female of plastic, be
sure of which screw fits to him in its position with the
screen.
G-H: The screens Fox have the option to connect a protector helmet, their positioning are very simple,
must disassemble the harness of screen i to place the helmet between both pieces as it is indicated in
these two figures.
I: Orientative view of the screen Fox with Protector helmet.
SOLTER
SOLDADURA S.L.
COATED MIG
ELECTRO- HEAVY
DES IRONS
TONE 8
TONE 9
TONE 10
TONE 10
TONE 11
TONE 11
TONE 12 TONE 12
TONE 13 TONE 13
TONE 14 TONE 14
MIG
LIGHT TIG
ALLOYS
TONE 8
TONE 9
TONE 10
TONE 11 TONE 9
TONE 12 TONE 10
TONE 11
TONE 13
TONE 12
TONE 13
TONE 14
TONE 14
TONE 15
MAG ARC / AIR
TONE 8
TONE 11 TONE 10
TONE 12 TONE 11
TONE 12
TONE 13
TONE 13
TONE 14
TONE 14
TONE 15 TONE 15
PLASMA
WELD
TONE 2,5
TONE 3
TONE 4
TONE 5
TONE 6
TONE 7
TONE 8
TONE 9
TONE 10
TONE 11
TONE 12
TONE 13
TONE 14
TONE 15
4