NIPRO Diagnostics TRUEtrack Configuración

Set Up
Start with the Meter off. Do not insert
a Test Strip.
1. Hold down the button until Meter
beeps and full Display appears. Meter
is now in Set Up mode.
Top
"+" "S" Select
Button Button
Coding Your Meter
1. Remove Code Chip
from Test Strip Box.
Match the number
printed on the
Code Chip to the
number on the Test
Strip Vial (plastic
container).
Blood Glucose Testing
1. Wash hands with warm, soapy water.
2. Remove Test Strip from vial and
recap vial immediately.
3. With Meter off, insert Test Strip (Contacts
facing up) into Test Port. Meter turns
on.
4. Confirm Meter Display and Code Chip
number matches.
WARNING!
NEVER reuse Test Strips. NEVER wipe test Strips with water, alcohol or any cleaner. DO NOT attempt to remove blood or control
sample from Test Strips or clean Test Strips and re-use. Reuse of Test Strips can cause inaccurate results. NEVER add a second drop
of sample to the Strip. Adding more sample gives an error message.
Data Management •
Always follow the treatment advice given to you by your doctor or diabetes
healthcare professional.
© 2011 Nipro Diagnostics, Inc. TRUEtrack and the Nipro Diagnostics logo are trademarks of Nipro Diagnostics, Inc.
Setting Time:
2. The number for the hour
flashes. Press the
button to increase or the
button to decrease.
Press the
the correct hour is shown.
3. Repeat Step 2 for minutes.
For more detailed information,
"–"
including a troubleshooting guide,
Button
refer to the Owner's Booklet.
5. Lance finger. Let a blood drop form.
6. Place Sample Tip of Test Strip against
blood drop and allow blood to be
drawn into Strip. Remove Sample Tip
from blood drop immediately after
Meter beeps and starts to countdown
on Meter Display.
Refer to the Owner's Booklet.
Scan this code with your smart phone
for additional TRUEtrack information.
Always refer to the Owner's Booklet
button when
2. Insert Code Chip
into your Meter
with the numbers
facing up.
A4NPD08 Rev. 23
for detailed product information.
Setting Date:
4. The number for the month
flashes. Press the
button to increase or the
button to decrease.
Press the button when
the correct month is shown.
5. Repeat Step 4 for day.
6. Repeat Step 4 for year.
CAUTION! Holding the Test Strip sample
tip to the blood sample too long after the
Meter begins testing may cause inaccurate
results.
Blood is drawn into Test Strip until
Meter beeps. (See Note below).
7. After countdown, glucose result
is displayed with date/time.
Remove Test Strip and
discard. Meter turns off. Test
result is stored in Meter's Memory.
Note: Discard Test Strip if Meter did
not begin testing within 5 seconds after
placing Tip of Test Strip against blood
drop. Repeat test with new Strip and new
blood sample. If problem persists, see
Troubleshooting in the Owner's Booklet.