Commissioning; Teach-In Of The Device - Alpha IP WRC2 61001 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
Alpha IP WRC2 61001
21

Commissioning

5 Commissioning
5.1

Teach-in of the device

Prior to operating the WRC 61001, it must be integrated into the Alpha
IP building automation system via the Access Point (HAP 21001). For this,
teach-in the device as follows.
Ö The Alpha IP Access Point has been set-up via the Alpha IP app (see
manual HAP 21001).
1. Open the Alpha IP app on your smart phone.
2. Select the menu item Teach-in device.
3. Pull the wall mount switch from the interchangeable frame (see fig. left).
4. Remove the insulating strip from the battery compartment. The teach-
in mode is automatically activated for three minutes.
The teach-in mode can be activated manually with the system key (see
„Device overview" page 20) for a duration of 3 minutes.
5. The device will be displayed automatically in the Alpha IP app.
6. For confirmation, enter the last four digits of the device number (SG-
TIN) or scan the supplied QR code. The device number can be found
below the QR code or in the battery compartment.
The LED will light up in green after a successful teach-in process. The
process must be repeated if the LED lights up in red.
7. Follow the directions of the Alpha IP app.
DEU
ENG
FRA
FIN
SWE
POL
NDL
ITA
ESP
RUS
DAN/NOR

Publicidad

Tabla de contenido
loading

Tabla de contenido