Commissioning; Teach-In With Alpha Ip Access Point - Alpha IP PS 21001 Manual De Instrucciones

Alpha IP PS/PSM 21001
25

Commissioning

5 Commissioning
CAUTION
Overheating!
Overheating due to improper use or wrong installation at the construc-
tion site of e. g. defective plugs or sockets, or such of inferior quality.
¾ If necessary, have the electric installation checked by an electrician
for possible defects.
¾ Observe and comply with the admissible environment conditions.
¾ Do not cover the device.
5.1

Teach-in with Alpha IP Access Point

Prior to operating the PS 21001 or PSM 21001, it must be integrated into
the Alpha IP system via the Access Point (HAP 21001). For this, teach-in
the respective device as follows.
Ö The Alpha IP Access Point has been set up via the Alpha IP app.
1. Open the Alpha IP app on your smart phone.
2. Select the menu item Teach-in device.
3. Connect the device to a fixed wall power socket. The teach-in mode
is automatically activated for three minutes. The device will be dis-
played automatically in the Alpha IP app.
The teach-in mode can be activated manually for 3 minutes via the
system key (see „Device overview" page 23).
4. For confirmation of the teach-in process, enter the last four digits of
the device number (SGTIN) in the app or scan the supplied QR code.
The device number can be found on the back side of the device.
The LED will light up in green after a successful teach-in process. The
process must be repeated if the LED lights up in red.
5. Follow the directions of the Alpha IP app.
DEU ENG FRA
FIN SWE POL
NDL ITA ESP
RUS
DAN/NOR