Bimar ND-18D3CL Folleto De Instrucciones página 16

• Position the fan heater far from other sources of heat,
inflammable materials (curtains, carpets, etc.), inflammable
gases or explosive materials (spray cans) and from materials
that can deform on exposure to heat. Make sure that there is
120 cm of free space in front of the fan heater and 150 cm on
the sides.
• Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool. (to avoid drops of water falling on the heater or the heater falling in the water), or in
places where it could be subject to shocks.
• The support surface must be stable (exclude shelf) and not sloping (since the heater could tip
over).
• Make sure that the air-intake grids and heating element are not obstructed by objects,
fabrics or anything else to avoid the heater overheating or breaking.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous
and render void the warranty.
OPERATION
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
ATTENTION: The heater should not be used if the glass or other parts are damaged.
For the use of a chimney, operates in the following way:
1. Insert the plug into the socket.
2. Open the drawer.
3. Flame Effect is operated by pressing light switch (3), pos.I the function is running. Flame
light intensity is adjusted by turning the knob "
the pos. maximum (clockwise). The fan heater is active only if the switch is in position "I" and
the knob is turned to the maximum position.
4. To operate the fan only, press "
5. To operate the heater, press the switches (4) in pos. "I" and (5) in pos. "I I". For get warm air
900W press (4) switch, and for get hot air 1800W press both switches (4) and (5). Thermostat
knob: regulates the appliance based on the surrounding ambient temperature: it heats
continuously until the set temperature is reached, and then it heats only when the temperature
decreases and for the period of time needed to bring it back up to the set temperature. Use the
respective knob: if turned fully in an anticlockwise direction, the fan heater stays off, if fully
turned clockwise it is set to the maximum temperature; the heater runs at intervals when set to
the settings in between.
7. To completely switch off the appliance, press all the switches
and "I I" and remove the plug from the socket.
" (2); will be greater as the knob is rotated to
". (3) and adjust the Knob (1).
16/44
on side opposed to
in pos. "I"