Wall-Mounting Placement - Linksys XAC1200 Manual Del Usuario

Linksys XAC-Series

Wall-mounting placement

The router has two wall-mount slots on its bottom panel. The distance between
the slots is 82 mm. Two screws are needed to mount the router.
Suggested Mounting Hardware
7-8 mm 1.5-2 mm
Note
Linksys is not responsible for damages incurred by unsecured wall-
mounting hardware.
Follow these instructions:
1. Determine where you want to mount the router. Make sure that the wall
you use is smooth, flat, dry, and sturdy. Also make sure the location is
within reach of an electrical outlet.
2. Using the template on the next page, drill two holes into the wall. Make
sure the holes are 82 mm apart.
3. Insert screws and leave 3 mm of heads exposed.
4. Position the router so the wall-mount slots line up with the two screws.
5. Place the wall-mount slots over the screws and slide the router down
until the screws fit snugly into the wall-mount slots.
3-5 mm
Wall-mounting template
Print this page at 100% size.
Cut along the dotted line, and place on the wall to drill precise spacing.
82 mm
Product Overview
3