Publicidad
6. Route the T-Connector ends with the green wires to the
passenger side of the vehicle and up through the opening
between the body and bumper near the right (passenger) side
taillight.
Caution: When routing wires, take care to avoid any
points that may pinch, burn or otherwise break the
wire.
7. Repeat steps 3 and 4 for the right (passenger) side tail
light housing using the T-Connector ends with the green
wires.
8. Locate a clean accessible mounting location on the
vehicle near the wiring harness ends within reach of the
white wire and grounding eyelet. Remove any debris or
undercoating to expose a clean metal surface and drill a
7/64" hole.
Caution: Take care not to drill through the body or
any exposed surface.
9. Mount the White wire using the ground screw and eyelet
provided.
10. Confirm correct operation with a test light or by using a
trailer.
11. Secure any loose wires with cable ties (provided).
12. Return the tail light housings to their original positions
and secure with the fasteners removed in step 2, taking care
not to pinch or damage any wires.
Publicidad
