Horizon Global 76332 Instrucciones De Instalación página 5

4. Trim heat shield – Using metal shears or hole saw, trim the heat shield
to clear rear carriage bolt & washer attachment as shown.
See figure 2.
2-3/4"
5b. Install fasteners – Using the same process, install the 7/16" carriage bolt
and 1/4 " x 7/8" x 3" spacer block (item 2) through access hole and into
the forward attachment hole. See figures 1 and 3.
©2019 Horizon Global™ Corp - Printed in Mexico
1-3/8" Diameter
Area to Trim
Figure 2
5a. Install fasteners – Feed the coiled end of pull wire through the first
attachment hole and out of the forward most access hole in the bottom
of frame. Attach the 7/16" carriage bolt and special washer (item 3) to
the pull wire and pull the fasteners into position, both sides.
6. Install ½" Flat washers – using tape, secure (2) 1/2" flat washers (item 6)
around the rearmost carriage bolts to bottom of frame, (1) per side. See
figure 4.
Sheet 5 of 21 76332NP 11-21-19 Rev. A