Using The Usb Socket; Led Flashlight; Proper Disposal - Wagan Tech iOnBoost V8 Manual De Usuario

User's Manual—Read before using this equipment

USING THE USB SOCKET

If the charge in the iOnBoost is low, the USB port will shut off to prevent damage to the iOnBoost.
Recharge the iOnBoost as soon as convenient.
1. Connect the USB device to the iOnBoost with either a user-supplied cable or the included
4-in-1 USB adapter.
2. Slide the master switch to the "I" position.
3. When your mobile device is fully charged, disconnect your device from the iOnBoost and
slide the master switch back to "O".

LED FLASHLIGHT

The light will automatically shut off before the iOnBoost runs out of power.
1. Set master switch to the "I" position.
2. Hold down the "MODE" button until the indicator lights turn on (~3 seconds).
3. Press once to switch lighting modes: steady – SOS – flashing – off.
4. After use, turn off the master switch ("O" position). Recharge battery as soon as convenient.

PROPER DISPOSAL

• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to a battery
recycling facility.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
All manuals and user guides at all-guides.com
©2015 Wagan Corporation. All Rights Reserved.
11