Dc Output Socket; Usb Power Port; Worklight - Wagan Tech 900 Amp Battery Jumper Manual De Usuario

900 Amp Battery Jumper™ by Wagan Tech

DC OUTPUT SOCKET

The DC accessory socket can power a DC load up to 15 Amps. Overloading the socket will result
in tripping a self-resetting circuit breaker. Removing the overload automatically restores power to
the DC socket. For proper and safe operation of the 12 Volt DC power accessory outlet, do not
place anything into it except the 12V DC plug of the accessory to be used.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the Battery Jumper's maximum wattage.
2. Open the dust cover from the DC socket.
3. Insert the 12V DC accessory plug into the socket.
4. Set the DC socket power switch (located above the DC socket) to the "||" position.
5. Operate the appliance as usual.
6. After use, turn the DC socket power switch off and disconnect the accessory plug from the
DC socket.
7. Replace the dust cover.
8. Recharge the Battery Jumper as soon as convenient.

USB POWER PORT

1. Connect a user-supplied USB cable to either of the USB power ports on the Battery Jumper.
2. Set the USB/DC Switch to the "|" position.
3. When charge is complete, set the USB/DC Switch back to the "O" position.
4. Disconnect the USB cable from the Battery Jumper.
5. Recharge the Battery Jumper as soon as convenient.

WORKLIGHT

1. Set the Worklight Switch to the "|" position.
2. The worklight will illuminate.
3. Turn the light off when it is not in use.
14
www.wagan.com
®