Dc Output Socket; Usb Power Port; Worklight - Wagan Tech JumpBoost V6 Air Manual De Usuario

JumpBoost™ V6 Air by Wagan Tech

DC OUTPUT SOCKET

The DC accessory socket can power a DC load up to 11 Amps. Overloading the socket will result
in tripping a self-resetting circuit breaker. Removing the overload automatically restores power to
the DC socket. For proper and safe operation of the 12 Volt DC power accessory outlet, do not
place anything into it except the 12V DC plug of the accessory to be used.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the JumpBoost's maximum wattage.
2. Open the dust cover from the DC socket.
3. Insert the 12V DC accessory plug into the socket.
4. Operate the appliance as usual.
5. After use, disconnect the accessory plug from the DC socket.
6. Replace the dust cover.
7. Recharge the JumpBoost as soon as convenient.

USB POWER PORT

1. Connect a user-supplied USB cable to either of the USB power ports on the JumpBoost.
2. When charge is complete, disconnect the USB cable from the JumpBoost.
3. Recharge the JumpBoost as soon as convenient.

WORKLIGHT

1. Press the light switch on the top of the unit to turn the light on or off.
14
®
www.wagan.com