Cequent Performance Products 36519 Instrucciones De Instalación

Vehicle
Vehicle
Frame end
Cross- member
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 36519F
Wrenches: 13mm, 9/16", 3/4", 7/8"
Drill bits: 1/2", to enlarge hole,
CXL AWD only.
Bolt-on bracket for 11
Regal , LaCrosse
*
CX & Malibu 8
models.
6 4
9
5
Slide handle nut through opening in bottom
of suspension mount. (Cut-away for detail.)
Loosen outside 8mm tailpipe hanger
bolt both sides vehicle (not shown),
for ease of installation.
1 1 1 1
Qty. (2) M8-1.25 x 40mm CL. 10.9 Bolt
2 2 2 2
Qty. (5) 3/8" Flat Washers
3 3 3 3
Qty. (1) Hex Bolt, 1/2"-13 X 2" Gr.5
4 4 4 4
Qty. (3) Conical Toothed Washer, 1/2"
5 5 5 5
Qty. (1) Hex Nut, 1/2"-13 Gr. 2
6 6 6 6
Qty. (1) Hex Bolt, 1/2"-13 X 1-1/2" Gr.5
7 7 7 7
Qty. (1) Hex Bolt, 3/8"-16 X 1-1/2" Gr.5
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water
and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection.
Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
z
2012 Cequent Performance Products, Inc.
Bumper
Fascia
All models including CX, CXL-FWD, CXL-AWD & CXS
Drawbar Kit:
36061
Drawbar must be used in the
Rise position only.
*2
12
4
*Use Star Washer, Flat
4
washer for Nut Rivet install
only.
3
Installation Instructions
Buick Lacrosse
Buick Regal
All models except GS model
Chevrolet Malibu
Do Not Exceed Lower of Towing Vehicle Manufacturer's Rating or
Hitch type
Weight Carrying
Ball Mount
Wiring Access Location: PC1 , PC2
Bolt-on bracket for
LaCrosse CXL & CXS
models.
Use (2) spacer washers per side,
between hitch and vehicle attachment.
2
8 8
Bolt-on bracket for
LaCrosse CXL &
CXS models.
Bolt-on bracket for
Regal , LaCrosse CX
& Malibu models.
8 8 8 8
Qty. (3)
9 9 9 9
Qty. (1)
Qty. (1)
11 Qty. (1)
Qty. (1)
12
13 Qty. (2)
Sheet 1 of 4
Max Gross
Trailer WT (LB)
3500 (1589 Kg)
2
Remove existing inner tailpipe
hanger 8mm bolts, and replace with
supplied 8mm bolts.
1
8
1 1
Figure 2.
Conical Toothed Washer, 3/8"
Handle-Nut, ½"
(Regal & CX-See *torque spec below)
Wire Hex Nut, 3/8"-16 (Use on CXL-FWD & CXS)
Nut Rivet, 3/8"-16 (Use on CXL-AWD)
Lock ,Star Washer, 3/8"-16 (Use on CXL-AWD)
Hex nut M8 x 1.25
36519N 5-23-12
Part Numbers:
36519
90099
06146
Max Tongue
WT (LB)
300 (136 Kg)
1
8
13
Rev. A
Form: F205 Rev A 5-6-05