Bimar Prontoforno B326.EU Folleto De Instrucciones página 10

All manuals and user guides at all-guides.com
Fax +32 030 9904733
I
•
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
D
•
o not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
P
•
eriodically check the good condition of the appliance and its components: in case of doubt,
contact an authorised service centre and make sure that the parts supplied are original.
INSTALLATION
•
After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam,
nails, etc.) must be kept out the reach of children because they are potential sources of danger;
dispose of them according to current regulations, in dedicated containers for differentiated
collection. Attention: any stickers or advertising material applied to the door must be removed
before using the appliance. The manufacturer declines all responsibility in case this is not safe
working practices will be respected.
•
Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity, and that the electric plug is grounded (the manufacturer declines any responsibility
for the lack of observation of this norm).. In the event of incompatibility between the electric outlet
and the plug of the appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the appliance. In general, the use of adapters or extension
cords is not recommended; if their use is indispensable, they must conform to existing safety
standards and their current capacity (amperes) must not be less that the maximum of the appliance.
•
The appliance must not be placed directly beneath a plug point.
•
The plug point must be easily accessible so as to easily remove the plug in case of an emergency.
•
Each time before use, check that the appliance is in good condition and that the electric cord is not
damaged: if in doubt, ask for professionally qualified help.
•
It is recommended to keep the appliance away from the edge of the work surface and out of reach of
children.
•
Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way, so the appliance cannot tip
over.
•
Place the appliance:
- far from other sources of heat (for example, other ovens, gas hobs, etc.), inflammable materials
(wallpaper, etc.), explosive materials (spray cans) and materials that would become deformed
when heated.
- on a flat and stable work top and not on delicate surfaces (painted furniture, tablecloths, etc.), in
a position where it cannot be bumped, and at a suitable distance from the edge so that it cannot
fall.
- far from containers of liquids, such as sinks, etc. Should it unexpectedly become wet or fall in a
liquid, remove the plug immediately from the socket, leave the appliance to cool, dry carefully
and make sure the electric parts are not wet; if in doubt, call qualified professional help.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
10
Assembly page 10/36