Cleaning And Maintenance - Bimar Prontoforno B326.EU Folleto De Instrucciones

All manuals and user guides at all-guides.com
Fax +32 030 9904733
When using for the first time
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Attention: do not leave the oven unattended while it is running.
before cleaning the appliance, remove the plug from the outlet.
Before being used for cooking, the appliance should be switched on "empty" to eliminate the "smell
of new" and any oils remaining from the production process. Insert the plug in the power socket, turn
thermostat to "max", turn the timer knob to position "20", position the selector knob
cycle ends, remove the plug from the socket and wait until the appliance is cool before removing the
accessories.
Using the oven
Generally speaking it is not necessary to preheat the oven, but for some foods (meat, pastries) it is
advisable to preheat the oven as described above, making sure the door is closed properly.
Put the shelf grids or/and enamel baking tray at the desired height in the slots in the oven.
• Place the enamel tray at the bottom of the oven.
• Put the food (in the plate or baking tray, etc.) and shut the door.
• Follow these instructions:
- Insert the plug in the power socket
- Turn the thermostat knob clockwise to the temperature required
- Turn the selector switch to desiderate position
- Turn the timer knob to the time required: the pilot light and inside lamp come on and the oven
starts to heat: if cooking time is not sufficient, restart the timer for the time still required.
• When cooking is completed, turn the selector switch to "
(100) and remove the plug from the power socket.
Attention: Never leave the appliance connected to the socket if it is not in use or before cleaning.

CLEANING AND MAINTENANCE

Warning: before cleaning the appliance, turn it off and unplug it from the power point. The appliance
and all the parts which come in contact with food (shelf grid, bake, etc.) require careful cleaning after
each use.
•
To clean the grill, bake tray, crumb tray use a soft sponge with warm water and household
washing up liquid. Then rinse with plenty of water, and dry thoroughly. Do not use steel wool or
abrasive products. The grill and crumb tray can be washed in the dishwasher.
•
The outer surface must only be cleaned with a soft cloth that has been slightly dampened either
with just water and/or detergent. It cannot be washed in the dishwasher, nor under a stream of
water: if the electrical parts (including the power cable and plug) get wet, dry carefully and
completely before using it again.
•
To clean inside the oven, do not use corrosive products nor scratch the internal surface with
sharp objects. Do not use steel wool or abrasive products. Clean with a slightly moist soft cloth
with common liquid detergents for dishes. Before using the appliance, make sure that it is
perfectly dry, especially the contacts.
•
If you decide to stop using the utensil, we recommend making it inoperative by cutting off the
power supply cord (after first making sure that the plug is removed from the mains socket) and
render harmless any parts possibly used as toys.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
; the thermostat to min. position
12
Assembly page 12/36
. When the