Protecting The Environment; Correct Disposal Of This Product; Technical Data - Black and Decker BDSL300 Manual Del Usuario

USE
1. Insert the vehicle DC power cord into the
accessory socket of your vehicle or other 12
volt DC power source.
2. To turn on the spotlight slide the power switch
to the on position (up).
3. To turn off the spotlight slide the power switch
to the off position (down).
Note:
When using a vehicle's 12 volt DC accessory outlet as a
power source, be aware that some vehicles require you
to turn on the ignition to power the accessory outlet.
Warning: To avoid the risk of property damage:
• Never connect the unit to a positive grounded
vehicle.
• The DC Vehicle DC Power cord must only be
connected to batteries with a nominal output
voltage of 12 volts. The unit will not operate
from a 6 volt battery and will sustain permanent
damage if connected to a 24 volt battery.
Caution! Do not operate the spotlight without
the original rubber ring guard and lens in place
over the bulb assembly.
MAINTENANCE
Your Black & Decker tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance or
cleaning of the tool, unplug the unit from the power
supply.
• From time to time wipe the appliance with a damp
cloth. Do not use any abrasive or solvent-based
cleaner. Do not immerse the appliance in water.
Replacing the fuse in the vehicle dc
power cord
If the spotlight does not turn on, the internal 12 amp
fuse may be open (blown).
1. Unscrew the flange of the DC plug
(counterclockwise).
2. Remove the end contact, flange and fuse.
3. Inspect the fuse to see if it is good or blown.
4. Replace with a new 12A/250V amp fuse, if
needed.
5. Carefully reassemble the fuse, end contact
and flange. Do not overtighten the flange
(clockwise).
BDSL300_Manual_041012.indd 4-5
ENGLISH

PROTECTING THE ENVIRONMENT

Correct disposal of this product

This marking indicates that this product should not
be disposed with other household wastes
throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To
return your used device, please use the return and
collection systems or contact the retailer where the
product was purchased.
They can take this product for
environmentally safe recycling.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials
helps prevent environmental pollution and
reduces the demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the household,
at municipal waste sites or by the retailer when you
purchase a new product.

TECHNICAL DATA

BDSL300
Bulb: H3, 12 volt/100 watts
DC Plug Fuse: 12A/250V
LIMITED GUARANTEE
Manufacturer issues this limited warranty to the
original purchaser of this product. This limited
warranty is not transferable and is only valid
for non-commercial use. Manufacturer warrants
this unit for 2 years from the date of purchase
against defective workmanship or material. It is
the obligation of the purchaser to forward the unit
together with proof of purchase to the manufacturer
or its representative with transportation cost
prepaid. This warranty is void if the unit is abused,
handled carelessly or repaired by anyone other
than manufacturer or its authorized representative.
Manufacturer makes no warranty other than this
limited warranty and expressly excludes any implied
warranty including any warranty for consequential
damages. This is the only expressed limited
warranty and manufacturer neither assumes nor
authorizes anyone to assume or make any other
obligation towards the product other than this limited
warranty.
4
ENGLISH
Baccus Worldwide LLC
Weena 290
3012 NJ Rotterdam or
Postbus 819, 3000 AV Rotterdam
5
4/10/2012 6:30:20 PM