Attaching The Fan Blades - HAMPTON BAY Umber Manual Del Propietário

1. Carefully unhook the fan from the mount-
ing bracket and align the locking slots of
the ceiling canopy with the two screws in
the mounting plate. Push up to engage the
slots and turn clockwise to lock in place. Im-
mediately tighten the two mounting screws
firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE EN-
GAGED AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the fan
blades.
Attaching the
Fan Blades
1. Attach blade to blade bracket using the
screws as shown in figure 14. Please note that
the rubber washers are pre-attached to the
blade bracket. Start a screw into the bracket.
Repeat for the two remaining screws
8.
Screws
Blade
Bracket
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot on
the bottom of the motor and tightening the
blade bracket screws. Please note that the
blade bracket screws are pre-installed into
the blade bracket (Figure 15).
4. Repeat steps 1-3 for the remaining blades.
Slot
Alignment Post
Screws
Blade / Blade
Bracket Assembly
Attaching the Light
Blade
Kit Assembly / Glass
Shade
CAUTION - To reduce the risk of electric
shock, disconnect the electrical supply circuit to
the fan before installing the light kit assembly.
1. Remove the three screws on the switch cup
Rubber
cover of the light kit assembly (Figure 16).
Washers
Figure 14
Reversing
Switch
Notch
Switch Cup
Cover
2. Connect the wires existing the bottom of
switch cup with the light kit assembly by
connecting the molded adaptor connectors
together.
Figure 15
Switch Cup
Blue
White
Serrated Head
Black
Screw (3)
Light Kit
Assembly
Figure 16