Hanging The Fan - HAMPTON BAY Umber Manual Del Propietário

Hanging the Fan

REMEMBER
to turn
er. Follow the steps below to hang your
fan properly.
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with
ball and socket mounting, and the "close-to-
ceiling" mounting. The "close-to-ceiling"
mounting is recommended in rooms with
less than 8-foot ceilings or in areas where
additional space is desired from the floor
to the fan blades. When using standard
downrod installation, the distance from the
ceiling to the bottom of the fan blades will be
approximately 11 inches. The "close-to-ceiling"
installation reduces the distance from the
ceiling to the bottom of the fan blades to
approximately 7 inches.
Once you have decided which ceiling
installation you will use, proceed with the
following instructions. Where necessary,
each section of the instructions will note the
different procedures to follow for the two
types of installation.
Standard Ceiling Mounting
1. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks (Figure 5).
4.
Turn Canopy Ring to Remove
off the pow-
2. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove the
mounting plate (Figure 6).
Loosen but
Do Not Remove
3. Route the wires exiting the top of the
fan motor through the decorative motor
collar cover then the canopy ring. Make sure
the slot openings are on top. Route the wires
through the canopy and then through the
ball/downrod assembly (Figure 7).
UL Listed
Outlet Box
Slide Mounting
Plate Over
Screw Heads
Figure 5
120V Wires
Motor Wires
Ball/Downrod
Assembly
Canopy
Canopy
Ring
Remove
Motor Collar
Cover
Hanger Pin
Motor Collar
Figure 6
Mounting Screws
(Supplied with
Outlet Box)
Hook
Ceiling
Mounting
Plate
Pin in
Locked
Position
Locking
Pin
Tighten
Screws
Figure 7