You must first install the software before you connect the camera to
your PC. After the software installation is complete, follow these
simple steps:
1. Using your fingernail,
open the USB port
door to access your
camera's USB cable
connector. (
2. Plug the square end
of the (supplied) USB
cable to the USB
connector in your
2
camera. (
3. Plug the rectangular
end of the USB cable into your PC's USB port.
(please refer to your PC's documentation if you do not know
where the USB port is.)
4. Turn your camera's power on.
5. Launch ArcSoft PhotoImpression
Start–Programs–ArcSoft Camera Suite and choose
PhotoImpression
DOWNLOADING PICTURES
)
1
)
from the application list on your screen.
™
software by clicking on
™
15