Drawer Removal - Whirlpool WD 142 / IXL Instrucciones Para El Uso

DRAWER REMOVAL
WARNING
• Use protective gloves.
• Disconnect the appliance from the power
supply.
The drawer can be removed to clean it
internally.
Open the drawer completely (figure 1).
Undo the four side screws (two on each side)
(figure 2).
Pull out the sliding part of the drawer carefully,
holding it at the front and side with both
hands.
The appliance can now be cleaned internally,
using detergent and water. Do not place the
drawer in water once removed.
Refitting the drawer
To refit the drawer, carry out the removal
procedure in reverse order.
To do this, place the drawer on the runners.
Make sure to:
Insert the drawer with the runners completely
out.
Hold the runners with one hand and push
the drawer until alignment of the 4 side holes
(fig. 4/5).
side runner
fig. 1
fig. 2
fig. 3
fig. 4
drawer
fig. 5
11