Electric Brake - Makita DCS551 Manual De Instrucciones

Sierra para metal inalámbrica
Ocultar thumbs Ver también para DCS551:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery indicator
015626
In this situation, the tool does not start even if turning
the tool off and on. To release the protection lock,
remove the battery, set it to the battery charger and wait
until the charging finishes.
Adjusting depth of cut
015629
CAUTION:
After adjusting the depth of cut, always tighten the
lever securely.
Loosen the lever on the side of the rear handle and
move the base up or down. At the desired depth of cut,
secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Sighting
1
015630
Place the alignment line of the base on your intended
cutting line on the workpiece.

Electric brake

This tool is equipped with an electric blade brake. If the tool
consistently fails to quickly stop blade after switch trigger
release, have tool serviced at a Makita service center.
The blade brake system is not a substitute for lower
guard. NEVER USE TOOL WITHOUT A FUNCTIONING
LOWER GUARD. SERIOUS PERSONAL INJURY CAN
RESULT.
On
Off
Blinking
Protection lock works
1. Lever
1
1. Alignment line
2
2. Cutting line
3. Base
3
Lighting the lamp
CAUTION:
Do not look in the lamp or see the source of light
directly.
015632
Only to turn on the lamp, pull the switch trigger without
pressing the lock-off lever. To turn on the lamp and run
the tool, press the lock-off lever and pull the switch
trigger with the lock-off lever being pressed. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out 10 -15 seconds after releasing the
trigger.
NOTE:
Use a cotton stick to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Do not use gasoline, thinner or the like to clean
the lens of lamp. Using such substances will
damage the lens.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing blade
CAUTION:
Be sure the blade is installed with teeth pointing
up at the front of the tool.
Use only the Makita wrench to install or remove
the blade.
2
015633
8
1. Lamp
1
1. Shaft lock
2. Hex wrench
1

Publicidad

Tabla de contenido
loading

Tabla de contenido