Recalling The Records; Deleting The Records; Tips For Measurement - Salter MiBody Manual De Instrucciones

RECALLING THE RECORDS

SET
1. Press button to access the memory. The monitor will display the last measurement data.
MEM
SET
2. Press button or button to rotate the history records.
SET
MEM
SET
to go forward;
MEM
to go backward.
SET
MEM
CAUTION
The most recent record (1) is shown first. Each new measurement is assigned to the first (1) record. All other records
are pushed back one digit (e.g., 2 becomes 3, and so on), and the last record (60) is dropped from the list.
If you want to check the other users' measurement data. Please press the START button to turn on the monitor to
select the correct user, press the STOP button to turn off the monitor. Then press "MEM" button to access the memory.
The User Guest only can check the last record.

DELETING THE RECORDS

When you did not obtain the accurate measurement, you can clear all the measuring results by following below steps.
1. Under Memory Recalling Mode, press and hold both the
2. When the LCD display blinking dEL ALL, press
The LCD will display dEL dOnE, indicating that memory clearing is complete. And then it will turn off automatically.
3. If you wish to cancel clearing, press
4. When there is no memory in the monitor, if you press the

TIPS FOR MEASUREMENT

It can cause inaccuracy if the measurement is taken in the following circumstances.
1. Within 1 hour after eating a meal or drinking.
2. Immediate measurement after tea, coffee or smoking.
3. Within 20 minutes of taking a bath.
4. When talking or moving your fingers.
5. In a very cold environment.
6. When you need the lavatory.
7. Rest for 5 minutes before measuring
8. Wait at least 3 minutes between measurements. This allows your blood circulation to recover.
9. Try to measure under similar conditions for example, take daily measurements at approximately the same time, on the
same wrist, or as directed by a physician.
MEM
SET
MEM
button to confirm clearing.
SET
MEM
to turn off the monitor.
START
STOP
SET
button for 3 seconds.
button to look up history, the LCD will display ---.
MEM
7
GB