Prestigio PHCBPM Manual De Instrucciones página 3

Quick Start Guide
Prestigio Smart Blood Pressure Monitor
3. Setting Date and Time
Please proceed to time setting before your initial use so as to
ensure each piece of record is labeled with a time stamp (Year
Range: 2012-2052; Time Format: 12 Hours).
1) When the monitor is OFF, press and hold
"SET" button for 3 seconds to enter Time
Setting Mode.
2) As pictured in the right, the blinking
numeral "6" represents [HOUR]. Press "MEM" button to
change the numeral. Each press will increase the numeral by
one in a cycling manner.
3) Press "SET" button again to confirm [HOUR], then the
numeral "00"representing [MINUTE] blinks.
4) Repeat step 2 and 3 to confirm [MINUTE].
5) Repeat step 2 and 3 to confirm [MONTH], [DAY] and [YEAR].
6) After confirming [YEAR], the LCD will display "dOnE" and the
monitor will shut off automatically.
Measurement
4. Positioning the Cuff
1) Remove all accessories (watch, bracelet, etc)
from your left wrist. If your physician has
diagnosed you with poor circulation in your
left wrist, use your right wrist.
2) Roll or push up your sleeve to expose the
skin.
3) Apply the cuff to your left wrist with your palm facing up.
4) Position the edge of the cuff about 1-1.5 cm.
5) Fasten the wrist cuff around your wrist, leaving no extra
room between the cuff and your skin. If the cuff is too loose,
the measurement will not be accurate.
Note:
• Have a rest for 5 minutes before measuring.
• Wait at least 3 minutes between measurements. This allows
your blood circulation to recover.
• For a meaningful comparison, try to measure under similar
conditions. For example, take daily measurements at
approximately the same time, on the same wrist, or as
directed by a physician.
MEM
SET