Installation; Installing Adapter On Hose End - Steinbach BP-39WS-B Mini Manual Original

2. Install the heat pump exactly as intended for later use.
3. Lay the hoses from the water treatment system to the installation site of the heat
pump (see Fig. F).
Make sure that all lines/hoses leading to the heat pump are not under stress and do
not obstruct any paths.
4. Install a cable for the power supply of the heat pump (see section "Technical data").
Use an extension cord or a socket with a protection class that is suited for the
ambient conditions at the connection site!
The installation site is ready.

Installation

Installing adapter on hose end

1
2
When using a filter system, this must be connected upstream from the heat
pump so that the filtered water flows through the heat pump.
1. Remove coarse dirt from the connection points of the heat pump
and the hose ends of the water pipes.
2. Screw an adapter
3. Screw an adapter
4. Connect the hose end of the drain with a hose clamp
water connection output
5. Connect the hose end of the feed with a hose clamp
water connection input
The adapters are installed on the hose ends.
3
onto the output of the water connection
2
onto the input of the water connection
2
(see Fig.1).
6
(see Fig.1).
7
, the adapters
1
.
6
.
7
and the adapter
3 2
and the adapter
3 2
2
to the
to the
51