Connecting The Lines; Display; Standby Mode; Operating Mode - Steinbach BP-39WS-B Mini Manual Original

Connecting the lines

Establishing the power supply
The MINI heat pump cannot be operated with an external timer and must be switched
on/off via the RCD adapter.
1. Connect the RCD adapter
The power supply has been established.
Connecting a drain hose for condensate (optional)
1. Insert the drain spout
2. Attach the drain hose (garden hose) for condensate to the drain spout
The drain hose for the condensate is connected.

Display

Standby mode

When in Standby mode, the heat pump is operationally ready but deactivated. Pressing
the On/Off button
15
After being switched on, the heat exchanger must first warm up before the
heat pump is ready for operation in the Operate mode. This process can take
up to 90 seconds.
Display:
G
14
- The Display shows the word "OFF".
14

Operating mode

In operating mode the heat pump heats the water up to the set water temperature. The
standard value for the set water temperature is 27°C. The set water temperature can be
between +15°C and +35°C. The heat pump switches into standby mode by pressing the
52
to the voltage supply set up at the installation site.
C
into the hole in the base plate.
4
switches the heat pump into the Operate mode.
15
Set
.
4