KMR 3509 Manual Del Usuario página 4

4 I English
1 TECHNICAL DATA
Type
Dimensions mm
Weight kg (without fasteners)
Single sequential or contact actuation
Switchable
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity.
No. of fasteners
Penetration depth setting
Fasteners: Wire bound nail coils
Nail length mm
Nail shank Ø mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2 NOISE/VIBRATION INFORMATION
Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPPLIED WITH
1 Coil nailer
1 Tool use and safety instructions
1 Technical data sheet
KMR
4
3509
Only those fasteners specified under technical data
(see 1) may be used.
306/268
When filling the magazine, hold the tool so that the
2.0 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
yoke or trigger depressed.
6 - 8 bar/0.4 -
To open the magazine, open the guide flap (k) using
0.6 MPa
the notch lever (l) and swing open the magazine (m).
The spring mounted support plate (n) can be adjusted
8 bar / 0.8 MPa
and fixed at 4 levels (a scale for the corresponding
2.1 l at 6
nail lenghts can be found in the magazine). Close the
bar / 0.6 MPa
magazine and lock the guide flap.
200-400
5
yes
-SINGLE TRIGGER RELEASE/RELEASE ON CONTACT-
A setting wheel on the trigger (s) can be turned to set
32-65
the type of actuation either to single trigger release
2.1-2.8
or release on contact (see symbol).
9 4420
6
68 3868
The penetration depth of the nail head is adjusted
using air pressure. Should this not suffice, a more
exact setting of the penetration depth can be achieved
by turning the setting nut (p).
3509
Right-hand turn (U) = less penetration depth.
Left-hand turn (D) = more penetration depth.
85 dB(A)
88 dB(A)
2,5 m/s2
FILLING THE MAGAZINE
SWITCHABLE ACTUATION
FIL PENETRATION DEPTH SETTING
3509