16/76
Bosch Rexroth AG
1 Safety instructions
1
Safety instructions
1.1
General
Read this technical information before put-
ting the press drive into operation.
Keep this technical information in a location
that is accessible to all users at any time.
1.2
Intended use
The Technical Information contains informa-
tion for the intended use of the device.
The products were developed, fabricated,
tested and documented observing the safety
standards. When observing the handling and
safety instructions for project implementa-
tion, mounting and proper operation the
product shouldn't be any danger for persons
or property.
1.3
Qualified personnel
This technical information addresses special-
ly trained technicians and engineers who
have special knowledge about the hardware
components of the device.
Any manipulation of the hardware and soft-
ware of our products that goes beyond what
is described in this documentation must be
performed by our experts.
Unqualified work on the hardware and soft-
ware or non-compliance with the warnings in
this documentation or posted on the product
may lead to severe injuries or damage.
SD301 | 3 609 929 827/06.06
Qualified personnel are:
– Project personnel, familiar with the safety
regulations of automation systems and
electrical engineering.
– Operators, instructed in the use of the
equipment and having knowledge of the
relevant operational parts of this docu-
mentation.
– Commissioning personnel, authorized
to set electric circuits and machines/sys-
tems into operation, earth and mark them,
in accordance with the regulations of se-
curity technology.
1.4
Safety notes in this technical
information
The following symbols are used in this tech-
nical information:
Warning:
This symbol is used when injuries
may occur if the instructions are
not followed precisely or at all.
Caution:
This symbol is used when damage
to devices or files may occur if
the instructions are not followed
precisely or at all.
Note:
This symbol is used when your at-
tention is to be drawn to some-
thing specific.