Troubleshooting - Onix CD-15A Guia Del Usuario

Description remote control buttons
RANDOM button: allows the random selection of tracks,
REP button: Press once to repeat a single track, press twice to repeat the entire CD,
A-B segment repeated play:
display A- in front of the track. Press A-B key again at the stop point of your desired content. Screen shall
display A-B in front of the track and the machine shall repeatedly play the segment between start point A and stop
point B until A-B key is pressed again to cancel segment
FAST REWIND/FAST FORWARD:
release this key to return to normal playback. During normal playback, press (
speed, release this key to return to normal playback.
TRACK SELECTING:
remote control to play the previous track.Press (
next track.
DISPLAY BRIGHTNESS ADJUSTMENT:
displayed characters, each time (DIMMER) key is pressed, screen brightness shall change from "bright", "normal"
to "dark" in circular. Screen will be set to "bright" as default when the machine is turned off.
MUTE buttom: pressing (MUTE) button while the CD is playing will activate the mute function (no sound), will,
display the message "MUTING" flashing, press the button (MUTE) for return to normal.
Protection
The device has a sophisticated protection circuit against the short circuits, distinguishing itself with the simultaneous
flashing of all LEDs for a few seconds, in such case, the power cord must be unplugged and leave it unplugged for
at least 15 minutes.

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong
with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the
other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the
checks listed below, ask your nearest ONIX authorized service center or your dealer to carry out repair work.
Symptom
No power
Power plug is disconnected from outlet
supplied to unit
Connecting cords are disconnected
from terminals, or connected
incorrectly
No sound
The position of the input selector does
not correspond to the component to be
played back.
No sound from Connecting cords or speaker cords are
one speaker disconnected.
Press A-B key at the start point of your desired content. Screen shall
During normal playback, press button (
Press numerical key 1 to 9 to select
Press (DIMMER) key on remote control to adjust the brightness of
Cause
screen shall display "R".
play.
.
track. Press (
) button on front panel or (
Check that power cord and insert the plug
securely into outlet
Check if connections between CD-player and
the amplifier are connected correctly.
Check that the selector on the amplifier is
positioned on the input of the CD.
Verify that the cables between amplifier and
CD-player are well- connected according to
the different polarity.
screen shall display
) to search backward at high
) button to search forward at high
) button on front panel or (
) key on remote control to play the
Remedy
"T" or "A".
speed,
) key on
5