Magnat Power Core One Limited El Manual Del Propietario página 9

fig. 1 power supplY / remote switCh-on ConneCtion
(1) terminal for +12 V battery voltage
(2) rem terminal for remote switch-on
(3) Gnd terminal for the ground, to the battery's minus pole
(4) Battery
(5) Cable fuse
(6) to your car radio's automatic aerial connection
if your car is not equipped with an automatic aerial connection, connect this cable's plus pole (+) to the ignition lock. An on/off switch
should be inserted in this case. make sure that this switch is switched off if the amplifier is not used.
fig. 2 operation with stereo Car raDio
Connect and set the amplifier as shown in Fig. 2 if it is to be controlled by a car radio with two output channels.
(1) to the car radio, left output
(2) to the car radio, right output
(3) Subwoofer
fig. 3 operation with one Car raDio with suBwoofer output
(1) to the car radio, subwoofer output
(2) Subwoofer
fig. 4 use in master/slave moDe
4a one subwoofer connected to each amplifier
4b one subwofer in bridge mode between 2 amplifiers
(1) to the car radio, subwoofer output
note: instead of a car radio with subwoofer output, a normal Stereo radio may be connected to the „Line inPUt" jacks (L and r).
(2) Subwoofer
fig. 5 operating elements anD in/outputs
(1) Slave input
(2) master output
(3) Low-level input
(4) input level control
(5) Cross-over frequency control for the low pass
(6) Cross-over frequency control for the subsonic filter
(7) Bass booster control
(8) Phase regulator
(9) master/slave switch
(10) Connection for volume remote control
9