Control Panel - Blomberg KSE 1550 i Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 139
GB

Control Panel

Switching on for the first time
To switch on the appliance be sure that the
plug is inserted to the mains and the ON/OFF
switch on the thermostat box is pushed.
(Fig.1-3)
Insert the plug in mains socket to switch on.
The green light (5) will light on.
The freezer temperature is pre-set to -18°C
but can be changed by the user. In addition,
the fridge temperature is also adjusted.
Do not load with food immediately.
The display shows fridge actual temperature
up to 19°C.
The display shows freezer actual temperature.
The appliance incorporates a protection device
in the electronics, therefore the appliance may
not start immediately – wait for about 6 minutes.
When it starts, you will then hear the
compressor and refrigerant gas flows (You
may also hear some cracking / popping
sounds which is normal).
The set temperature will not be reached for
approximately 8 hours and the display may
fluctuate during this period. This is not a fault.
When the correct storage temperatures have
been reached (approximately 8 hours), you
can start loading food.
When the fridge door is opened the interior
light will come on.
The front edges of the cabinet are designed
to avoid condensation and may feel warm to
the touch.
Temperature display & adjustment
Operating temperatures are controlled by the
electronical thermostat knobs and may be set
any position between MIN and MAX (coldest
position)
(Fig.2)
a) Fridge
The display (7) shows average temperature
in fridge compartment.
The fridge temperature will display from –5 to
+19°C with respect to internal temperature.
The average temperature inside the fridge
should be around +4°C (+41°F).
b) Freezer
The display shows the actual average
temperature in the freezer compartment.
The set temperature will not be reached for
approximately 8 hours and the display may
fluctuate during this period. This is not a fault.
To display the currently set freezer temperature,
turn the freezer knob (2). The new freezer set
temperature will flash (3)
Freezer temperature will display from –30 to
+30°C with respect to internal temperature.
The average temperature inside the freezer
should be equal or colder than -18°C (0°F)
IMPORTANT: When you changed the freezer
set temperature, with for approximately 8 hours
to allow the freezer compartment to reach and
maintain to new setting.
Door left alarm:
If the fridge door is left open for longer than 1
minute, an audible alarm will sound to alert
you to close the door as soon as possible. To
switch it off close the door.
4
Instruction Manual

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kse 1551 i a+

Tabla de contenido