Raider Pro RDP-HG21 Manual Del Usuario página 8

8 www.raider.bg
soft wire brush.
5.3. Shaping plastic tubing. Fit the reflector nozzle. To avoid kinking the tubing, fill the
tubing with sand and seal at both ends. Heat the tubing evenly by moving it from side to side.
5.4. Staining wood. Fit the flat nozzle. Hot air staining gives natural wood a rustic effect. Do
not hold the nozzle too close to the wood as this will color the wood unevenly. Carefully grind
off any singed wood fibres after-wards using fine emery paper.
5.5. Shrink fitting. Fit the reducing nozzle. Select a heat-shrinkable sleeve (see Accessories)
with a diameter matching that of the workpiece, e.g. cable lug. Heat the heat-shrinkable sleeve
evenly.
5.6. Defrosting water pipes. Do not attempt to defrost PVC piping. Fit the reflector nozzle.
Always heat the frozen area inwards from the edge to the centre. Note: Water pipes are often
difficult to distinguish from gas pipes. Copper pipes are joined using tin and should therefore
not be heated above 200°C.
6. Care and maintenance. Always disconnect the plug from the power socket before carrying
out any work on the appliance. Always keep the ventilation slots unobstructed and clean.
7. Preservation of the environment.
In view of environmental power, additional accessories and packaging must be subjected
to appropriate processing for reuse of the information contained in these materials. Do not
dispose of electric household waste! Under the EU Directive 2002/96/EC on waste electrical
and electronic devices and validation and as a national law power which can be used more,
must be collected separately and be subjected to appropriate processing for recovery of
contained they scrap.
fig 1