G-Systems ED11-201EU Manual De Instrucciones página 23

G-Systems Engineering
On the down left side speed bar you can see the actual setting for each filled
segment is 10% fan speed. Change the settings again with SET/SAVE as
described above.
Maximum speed setting day time. Here you can choose the maximum speed
setting of the ventilator which never should be exceeded. On the top left side
you can see the actual missing empty segments each is 10% fan speed.
Change the settings again with SET/SAVE as described above. Repeat all 6
settings we explained for day time now you can give the night time values of the
fan.
After you have gone through the 6 night time settings in the menu, you can set
the light level switch value of the light sensor.
max .
You see the alternate blinking of
sun and moon segments. Enter
SET/SAVE to change the switch
level value between day and
night time. The lower the value,
as less light it needs to change
from day to night time mode.
This last setting is the switch
over time between day and night
mode. This is used to avoid an
immediate switching between
day and night mode.
If the light sensor reaches the
switching level a count down
starts according to the value in
seconds you are entering here.
As the countdown ends without
getting a light interrupt at the light
sensor the controller will switch
from night to day time or reverse
from day to night time. Enter
SET/SAVE to change the
values.
The Power LED indicates the
state of the fan. Blinking means
initializing the fan. Constant
shining at day time or short blink
at night time means the fan is ON
and running.
EN
21