G-Systems FC15-EU-GSE Manual De Instrucciones página 31

CZ G-Systems Engineering
To change the temperature value push the SET/SAVE button once. The
settings start to blink, now you can change the value with the UP and DOWN
buttons. Set the desired temperature for the day time indicated with the sun
symbol. Push again SET/SAVE to save the setting and return to the selection
of settings. In case you forget to confirm the changes the LCD display returns
to the main screen after 2min. without saving.
EN
What is hysteresis? Hysteresis is the value between the lowest and the
highest point of the regulation. Example: if we set 25C° and have a hysteresis
of 2C°. this means the fan starts to work at >25C° room temperature and
reaches the maximum speed +2C° hysteresis at 27C°. In this 2C° hysteresis
from 25C°-27C° the fan is running faster and slower depending on the
measured temperature.
To change the value use again SET/SAVE button to enter the setting,
change the Value with UP/DOWN button and save and return to the selection
with SET/SAVE again.
min.
14 10 28
Go to the next setting with
the DOWN button. Temperature
hysteresis setting.
With the DOWN button you
go to the next setting "humidity
setting day time" repeat again,
e n t e r t h e s e t t i n g s w i t h
SET/SAVE or go to the next
setting with the DOWN button
Hysteresis setting for the
humidity day time, as described
a b o v e t h e h y s t e r e s i s f o r
temperature you can change
here the controlling range for the
humidity value.
For example: 10%rh at 60%
humidity the fan starts to work at
60% humidity and +10%rh at
70%rh it reaches its maximum
speed.