Replacing Sensors - WIK GA11 Manual De Instrucciones

8. Replacing sensors

8. Replacing sensors
The replacement of sensors must only take place in an ESD-compatible
environment.
The actual sensor can differ visually from the sensor module shown. The
functionality for the sensor replacement is, however, identical.
1. Switch off and disconnect the analytic instrument from the mains. Remove the 4
screws of the front panel (see arrows) and fold back the front panel.
2. Pull the plug off the sensor (in this example: SO
3. Screw out the sensor counterclockwise.
WIKA operating instructions analytic instrument, model GA11
sensor)
2
EN
31