Silverline 398920 Manual Del Usuario página 7

GB
Unpacking & Assembling Your
Pressure Washer
• I f any parts are damaged or missing, have these parts repaired or
replaced before assembling or using this product.
• D o not connect the pressure washer to the water, or electrical supply
until fully assembled and ready for use.
• R emove all packaging materials from the product.
Lance Assembly:
• A ttach Lance (6) to handle (5) by screwing together. Tighten firmly by
hand.
• A ttach small end of high pressure hose (8) to brass threads on handle
(5) as shown in the diagram. Tighten with a 17mm spanner.
• U ncoil the rest of the high pressure hose (8)
• S crew the large end of the high pressure hose (8) on to the high
pressure outlet (9) and tighten by hand.
Water Supply
• Ensure the water supply is turned off.
• S crew the orange plastic hose quick connector on to the water inlet (3)
and tighten by hand.
• C onnect the hose. You will hear a click when the two parts connect.
Check the connection by tugging on the hose.
Detergent
This pressure washer includes an automatic detergent dispenser.
The sight guide enables you to see the level of detergent in the reservoir.
To add detergent:
• Unscrew the detergent reservoir cap (1)
• Carefully pour detergent into the reservoir
• Replace the reservoir cap and tighten by hand
Operating the pressure washer
• Check that the switch (10) is set to O/OFF position.
• Turn on water supply.
• C heck the water supply connections, and make sure there are no leaks.
Fix any leaks before proceeding.
• U nwrap the mains lead (2) and fully extend. Plug in to an appropriate
mains supply.
• Switch on by turning switch (10) to I/ON
• Hold the assembled lance (6 & 7) firmly with both hands.
• P oint away from any person or object and disengage the safety lock
off device.
• Squeeze the Trigger (4) fully.
• N OTE: On first use the water will not flow evenly. There will be air in the
hose and pipes which will release after a few minutes use.
• To stop the pressure washer, release the trigger (4)
• W hen not in use, engage the safety lock off device so that the trigger
cannot be depressed
• T he spray pattern can be adjusted by holding the lance (6) and turning
the nozzle (7)
6
Maintenance
Cleaning
• Keep your machine clean at all times.
• T o access and clean the water supply filter, unscrew the hose quick
connector
• Always allow all water to drain from the pump before storing.
Storage
• Always store this machine in a dry place that will not fall below 0˚C
Disposal
• D o not dispose of power tools, or other waste electrical and electronic
equipment, with household waste.
• C ontact your local waste disposal authority for information on the
proper way to dispose of tools.