H-7261
STEEL LED
EMERGENCY LIGHT
TOOL NEEDED
Phillips Screwdriver
CAUTION! When using electrical equipment,
always follow basic safety precautions, including:
• Do not use outdoors.
• Mount in locations and at heights where it
will not readily be subjected to tampering by
unauthorized personnel.
• Do not mount near gas or electric heaters.
• Use of accessories not recommended by the
manufacturer may cause an unsafe condition.
1.
Remove front cover of unit by removing screws on
both ends. (See Figure 1)
Figure 1
2. Run conduit and AC wires to unit through knockouts
on the side or back of unit.
PAGE 1 OF 6
1-800-295-5510
uline.com
SAFETY
INSTALLATION
3. Remove 6 Volt battery from packaging and place in
Pour le français, consulter les pages 5-6.
• Do not use this equipment for anything other
than intended use.
• Disconnect AC power and unplug battery
before servicing.
• Only qualified personnel should perform
servicing on this unit.
NOTE: Battery in unit may not be fully charged.
After AC service is supplied to unit, let battery
charge for at least 24 hours before performing
any tests.
unit with terminals facing up. (See Figure 2)
NOTE: Battery (+) connects to red wire from
circuit board.
NOTE: Battery (-) connects to blue wire from
circuit board.
Figure 2
Red
Wire
Circuit
Board
Para Español, vea páginas 3-4.
Blue
Wire
Battery
0321 IH-7261