Electrical Safety - EKO Device Eko CORE Manual Del Usuario

15. Electrical Safety

Declaration - Electromagnetic Emission
The Eko Electronic Stethoscope System is intended for use in the electromagnetic
environment specified below. The user of the Eko Electronic Stethoscope System should
assure that it is used in such an environment.
Applicable
Emissions Test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic Emissions
IEC 6100-3-2
Voltage fluctuations /
flicker emissions IEC
61000-3-3
Warning: The use of accessories other than those specified, with
the exception of accessories sold by Eko as replacement parts,
may result in increased emissions or decreased immunity of the
Eko Electronic Stethoscope System.
Warning:
The Eko Electronic Stethoscope System should not be
used adjacent to or stacked with other equipment. If adjacent
or stacked use is necessary, the Eko Electronic Stethoscope
System should be observed to verify normal operation in the
configuration in which it will be used.
24
Guidance and Manufacturer's
Compliance
Group 1
Class B
Not Applicable
Not Applicable
Electromagnetic
Environment- Guidance
The Eko Electronic Stethoscope System
uses RF energy only for its internal
function. Therefore, its RF emissions
are very low and are not likely to cause
any interference in nearby electronic
equipment.
The Eko Electronic Stethoscope System
is suitable for use in all establishments,
including domestic establishments and
those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.